DM-D500 Installation Guide 19
English
Required items
The items shown in illustration 44 are used when the DM-D500 is
used with other TM printers. These items are packed with the
“DM-D pole unit for TM printers (Type
A)” (DP-502).
Assembling using Velcro tapes
1. Attach Velcro tapes to the bottom of
fixing plate
A as shown in
illustration
45.
2. Pass the cable for the DM-D500 through support C, and attach
support
C to the DM-D500 as shown in illustration 46. When
using support
B for extension, insert the tab on support B into
the hole on support
C as shown in illustration 47 until you feel
it click.
44
fixing plate A
Velcro tapes Velcro tapes
support B
(for extension)
support C
fixing screws for
wood position
45
46 47
when using support B
for extension
To Next Page
Loading...
