Epson DM-D500 - Jumper Settings

22 DM-D500 Installation Guide
English
Connectors for the DM-D stand
The connectors for the DM-D stand are shown in illustration 55.
Note:
The DM-D stand comes with inch-type hexagonal lock screws installed to
secure the interface cable to the interface connector for the RS-232. If you
plan to use an interface cable that requires millimeter-type lock screws,
replace the inch-type screws with the included millimeter-type screws
using a hex screwdriver (5 mm {0.2"}). To distinguish the two types of
screws, see illustration 56.
Jumper settings
Set the jumpers on the DM-D stand as follows:
The jumpers are located as shown in illustration 57.
JP1 JP2 Contents
1-2 1-2 When connecting both the TM printer and the DM-D stand. (Default setting.)
2-3 2-3 When using the DM-D stand as a standalone. (TM printer is not connected.)
55
printer connector
display connector
extension cable connector
power supply unit connector
computer connector
notch (one or more lines)
RS-232 connector
installation screw
millimeter-typeinch-type
56
57