DM-D500 Installation Guide 23
English
Precautions on using the power supply unit
To avoid damage to the DM-D500 and the power supply unit, note
the following points.
❏ Use the optional Seiko Epson product, PS-180, as the power
supply.
❏ Never connect the DC cable to the power supply unit when the
power supply unit is connected.
❏ Unplug the DC cable by holding the connector part. If you pull
the cable to unplug it, it may be damaged.
Assembling
1. Pass the cable for the DM-D500 through the DM-D stand as
shown in illustration 58. When raising the height of the DM-D
stand, attach the extension support (DP-105) to the DM-D stand
as shown in illustration 59.
2. Insert the tab on the DM-D500 (or the
extension support) into the hole on the
DM-D stand as shown in illustration
60 until you feel it click.
58 59
when using the
extension support
(DP-105)
60
To Next Page
Loading...
