Epson DM-D500 - Page 28

26 DM-D500 Installation Guide
English
7. Connect the DC cable of the power supply unit (with the arrow
mark up) to the power supply unit connector indicated with
“POWER IN” on the DM-D stand as shown in illustration 65.
8. When using as a standalone product, set the jumpers as shown
in “Jumper settings” on page
22.
9. Arrange the cables as shown in
illustration 66. Put the cables for the
DM-D500 inside the DM-D stand.
10. Attach the base plate to the DM-D stand following the numbers
of the arrows shown in illustration 67. Then, push the base
plate until it is locked by the hook on the DM-D stand.
11. When the extension support (DP-105) is used, attach Velcro
tapes to the four corners of the plate to keep it from falling
down.
12. Connect the cord of the power unit to the socket.
65
DC cable of
power supply unit
power supply unit
connector
66
67