2.
Extend the input tray extension. Pull out the output tray extension to the length of the original. Raise the
stopper if necessary.
Note:
❏ To stack the original properly, pull out the output tray and output tray extension so that it is slightly longer than the
length of the original.
❏ If thick originals bump into the output tray and fall from it, store the output tray and do not use it. Let the ejected
originals stack directly onto the table where the scanner is placed.
❏ If scanned images are still
aected
by ejected originals hitting the table surface the scanner is placed on, move the
scanner to the edge of the table where the ejected originals can drop freely, and catch them directly.
3.
While holding the tab, slide the edge guides all the way out.
4.
Follow the instructions below to load originals with a fold.
Note:
Depending on the folded state of the original, it may not be fed correctly. In this case, support both ends of the originals
with your hands.
Placing Originals
>
Placing Standard Size Originals
>
Placing A3 Size Originals with Fold Lines
38
To Next Page
Loading...
Need help?
General
