You can save the image that is currently being projected as a User's Logo.
q
When a User's Logo is saved, the previous User's Logo is erased.
Procedure
A
Project the image you want to save as the User's Logo, and
then press the [Menu] button.
Using Remote Control Using Control panel
B
Select User's Logo from the Extended menu in the
Configuration Menu.
s "Using the Configuration Menu"
p.73
Check the buttons you can use and the operations they perform in
the guide under the menu.
q
• When User's Logo Protect from Password Protect is set to On, a
message is displayed and the User's Logo cannot be changed. You
can make changes after setting User's Logo Protect to Off.
s p.50
• If User's Logo is selected when one of the Keystone, E-Zoom,
Aspect, Progressive, and Zoom Adjustment functions is being used,
the function currently being used is cancelled temporarily.
C
When the message "Choose this image as the User's Logo?" is
displayed, select Yes.
q
When you press the [Enter] button on the remote control or the
control panel, the screen size may change depending on the signal to
match the actual resolution of the image signal.
D
Move the box to select the part of the image to use as the
User's Logo.
Saving a User's Logo
68
To Next Page
Loading...
