Installing the Setting Plate
15
Caution
When installing two or more projectors in parallel, leave a gap of at least 750mm between
the projectors.
750mm
If you cannot secure a gap of approx. 750mm, install a partition to block the heat vented from the
projector's air exhaust vent.
Ensure the following space when installing partitions.
350mm 100mm
Install and adjust the projector at a room temperature that is close to the actual intended
usage environment.
If the temperature changes, the position of the image may shift.
Install the projector so that it is tilted at an angle of no more than +3 degrees or -3 degrees
vertically and horizontally in relation to the screen.
We recommend using stick-on screens or board screens.
To Next Page
Loading...
