Setting the Projector
69
f
While holding down the [ID] button, press the button with the same number as the
projector ID for the projector you want to operate
Remote control operations for the projector with the selected ID are enabled.
c
•
When Projector ID is set to Off, you can operate the projector using the remote control
regardless of the ID setting selected using the remote control.
•
When the remote control ID is set to 0, you can operate all of the projectors regardless of the
projector ID setting.
•
Operating multiple remote controls at the same time can cause accidental operations due to
infrared interference.
HDMI Link Settings
Use HDMI Link to link the power on/off function across multiple projectors.
a
Press the [Menu] button
Using the Remote Control Using the Control Panel
b
Select HDMI Link from the Signal I/O
To Next Page
Loading...
