Installing the Setting Plate
22
Installing the Setting Plate
Follow the work flow below to install the setting plate.
Route the cables before installing the wall mount according to your installation environment.
a
Remove the feet from the projector (3 places in total), and then attach the rubber caps to the front foot
section.
b
Check the projection distance tables to determine the installation position (s p.23)
c
Attach the adjustment unit to the projector (s p.35)
d
Install the wall plate on the wall (s p.36)
e
Adjust the arm length of the arm unit, and then attach it to the wall plate (s p.38)
f
Attach the adjustment unit to the arm unit, and then connect the cables and peripheral devices
(
s p.43)
g
Adjust the position of the image (s p.46)
h
Attach the covers (s p.57)
To Next Page
Loading...
