Epson EB-G6900WU - Performing edge blending

To continue to correct another point, press the [Esc] button to
return to the previous screen, and then repeat steps 6 and 7.
a
Each time you press the [ ] button, you can show or hide the
image and the grid.
h
When you are done, press the [Menu] button to exit the correction
menu.
Checking the Color Mode
Set the Color Mode to Multi-Projection (or 3D Multi-Projection for 3D
images).
s p.49
Adjust the Edges of the Images (Edge Blending)
When multiple projectors are lined up and projecting images, you can
create a seamless screen.
Adjusting the brightness of the lamp
Before performing edge blending, adjust so that the lamp brightness is the
same for each projector.
Adjust so that all projectors are the same brightness as the darkest lamp.
You can adjust the brightness in five levels.
a
• Set Power Consumption to Normal.
s Settings - Power Consumption p.90
• Even if you adjust the Brightness Level, the brightness of each lamp
may not match exactly.
a
Press the [Menu] button while projecting.
b
Select Multi-Projection from Extended.
c
Select Brightness Level, and then press the [ ] button.
d
Select 1 to 5 as the brightness.
e
Press the [Esc] button to return to the previous screen.
Performing edge blending
a
Press the [Menu] button while projecting.
s
"Using the Configuration Menu" p.84
b
Select Multi-Projection from Extended.
c
Select Edge Blending, and then press the [ ] button.
The following screen is displayed.
Multi-Projection Function
59