d
Use the [ ], [ ], [ ], and [ ] buttons to select the corner you
want to adjust, and then press the [
] button.
a
If the [Esc] button is pressed for at least 2 seconds, the confirm
default reset screen is displayed.
Select Yes to reset the result of Quick Corner corrections.
e
Use the [ ], [ ], [ ], and [ ] buttons to correct the position of
the corner.
When you press the [
] button, the screen shown in step 4 that
allows you to select the area to be corrected is displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Menu] button to exit the correction
menu.
Curved Surface
a
• Project from the front with lens shift in the center.
s "Adjusting the Position of the Projected Image (Lens Shift)"
p.24
• Project onto an arc surface with the same radius.
• If a large amount of adjustment is performed, the focus may not be
uniform even after making adjustments.
a
Press the [Menu] button while projecting.
b
Select Geometric Correction from Settings.
Adjusting Projected Images
44
To Next Page
Loading...
