c
Select Curved Surface, and then press the [ ] button.
If the message "If this setting is changed, the image may be
distorted." is displayed, press the [
] button.
d
Select Correct Shape, and then press the [ ] button.
e
Use the [ ], [ ], [ ], and [ ] buttons to select the area you
want to adjust, and then press the [
] button.
When selecting a corner, you can adjust the two sides next to the
corner.
a
If the [Esc] button is pressed for at least 2 seconds, the confirm
default reset screen is displayed.
Select Yes to reset the result of Curved Surface.
f
Use the [ ], [ ], [ ], and [ ] buttons to adjust the shape.
If the triangle in the direction you are adjusting the shape turns gray,
as shown in the screenshot below, you cannot adjust the shape any
further in that direction.
g
Press the [Esc] button to return to the previous screen.
Adjusting Projected Images
45
To Next Page
Loading...
