h
Repeat procedures from 5 to 7 as needed to adjust any remaining
parts.
If the image expands and contracts, go to the next step and adjust
the linearity.
i
Press the [Esc] button to return to the screen in step 4. Select
Horizontal Linearity or Vertical Linearity, and then press the [
]
button.
Select Horizontal Linearity to adjust the horizontal expansion or
contraction, and select Vertical Linearity to adjust the vertical
expansion or contraction.
j
Select the standard line for the adjustments, and then press the
[
] button.
Use the [
][ ] buttons when selecting the Horizontal Linearity,
and the [
][ ] buttons when selecting the Vertical Linearity, and
then press the [
] button.
The selected standard line is displayed in flashing red and white.
k
Adjust the linearity.
When the [
] is pressed
Selecting the Horizontal Linearity Selecting the Vertical Linearity
When the [ ] is pressed
Selecting the Horizontal Linearity Selecting the Vertical Linearity
l
When you are done, press the [Menu] button to exit the correction
menu.
a
You can fine tune the results of Curved Surface using Point
Correction. Change Geometric Correction to Point Correction, and
then make adjustments after selecting Keep the current geometric
correction settings.
s "Point Correction" p.57
Adjusting Projected Images
46
To Next Page
Loading...
