195
Note: If you don't know the projector's ID, press the ID button to temporarily display the projector's ID on
the screen.
Parent topic: Projector Identification System for Multiple Projector Control
Setting the Remote Control ID
The remote control's ID is set to 0 by default so it can operate any compatible projector. If you want to set
the remote control to operate only a particular projector, you need to set the remote control's ID to match
the projector's ID.
1. Turn on the projector you want the remote control to operate with exclusively.
2. Set the remote control ID switch to On.
3. Press and release the ID button. Within 5 seconds, use the numeric buttons to enter a number for
the projector (for example, 1 for projector ID 1).
Note: If you don't know the projector's ID, press the ID button to temporarily display the projector's
ID on the screen. If the batteries are left out of the remote control for an extended period, the remote
control ID returns to its default setting.
To Next Page
Loading...
