48
7. Replace the lens cover.
8. If prompted, select Yes to calibrate the lens.
Note: If no message appears after attaching the lens, perform lens calibration by holding down the
Default button on the remote control for approximately 3 seconds, or you can go to Extended >
Operation > Lens Calibration in the projector menu.
Note: Lens calibration helps the projector to correctly acquire the lens position and adjustment
range, and can take up to 100 seconds to complete. When calibration is finished, the lens returns to
the same position it was in before calibration (ELPLX01/ELPLX01S, ELPLX01W/ELPLX01WS,
ELPLX02/ELPLX02S, ELPLX02W/ELPLX02WS returns to the standard position).
9. When using one of the following lenses, select the lens type in the Extended menu: ELPLS04,
ELPLU02, ELPLR04, ELPLW04, ELPLM06, ELPLM07, or ELPLL07.
If projecting down, we recommend securing the lens cover with commercially available screws
(M3×12mm).
To Next Page
Loading...
