Epson EB-U04 User Manual

132
Replacing the Remote Control Batteries
The remote control uses two AA manganese or alkaline batteries. Replace the
batteries as soon as they run out.
Warning
Check the positions of the (+) and (–) marks inside the battery holder to
ensure the batteries are inserted the correct way. If the batteries are not used
Attention
correctly, they could explode or leak causing a fire, injury, or damage to the
Make sure you read the Safety Instructions before handling the batteries.
product.
a
Open the battery cover as shown.
d
Close the battery cover and press it down until it clicks into place.
b
Remove the old batteries.
c
Insert the batteries with the + and – ends facing as shown.

Epson EB-U04 Specifications

General

Contrast Ratio	15, 000:1
Lamp Life	Up to 10, 000 hours (ECO mode)
Weight	2.6 kg
Resolution	WUXGA (1920 x 1200)
Dimensions	297 x 244 x 77 mm
Projection System	3LCD Technology
Keystone Correction	Vertical: ±30 degrees, Horizontal: ±30 degrees
Zoom	Factor: 1.2
Interfaces	HDMI in, VGA in, Composite in, USB 2.0 Type B, USB 2.0 Type A
Security	Kensington lock
Projection Size	30 inches - 300 inches
Input Ports	VGA, HDMI, Composite, USB
Brightness	3000 Lumens (White), 3000 Lumens (Color)