EasyManuals Logo

Epson EB-X14H User Manual

Epson EB-X14H
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Check Remedy
Are the image signals being output to the projector?
(Only when projecting images from a laptop computer or a
computer with a built-in LCD screen)
If the image signals are only being output to the computer's LCD monitor or to the accessory monitor, you need to
change the output to an external destination as well as the computer's own monitor. For some computer models, when
the image signals are output externally, they no longer appear on the LCD monitor or accessory monitor.
If the connection is made while the power of the projector or computer is already turned on, the Fn key (Function key)
that changes the computer's image signal to external output may not work. Turn the power for the computer and the
projector off and then back on again.
s "From Installation to Projection" p.26
s Computer's documentation
Images are fuzzy, out of focus, or distorted
Check Remedy
Is Auto V-Keystone set to Off?
(EB-X15 only)
Setting it to On enables Auto V-Keystone.
s Settings - Keystone - H/V-Keystone - Auto V-Keystone p.60
If you are using the projector with this setting off, manually adjust the projected image.
s "Correcting manually" p.33
Is the focus adjusted correctly? Turn the focus ring to adjust the focus.
s "Correcting the Focus" p.37
Is the projector at the correct distance? Is it projecting outside of the recommended projection distance range?
Setup within the recommended range.
s "Screen Size and Projection Distance" p.88
Is the keystone adjustment value too large? Lower the projection angle to reduce the amount of keystone correction.
s "Adjusting the Image Position" p.36
Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature
changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the
projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and
wait for the condensation to disappear.
Problem Solving
72

Table of Contents

Other manuals for Epson EB-X14H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-X14H and is the answer not in the manual?

Epson EB-X14H Specifications

General IconGeneral
BrandEpson
ModelEB-X14H
CategoryProjector
LanguageEnglish

Related product manuals