Air Filter and Vent Maintenance
59
Regular filter maintenance is important to maintain your projector. Clean the
air filter when a message appears telling you the temperature inside the
projector has reached a high level. It is recommended that you clean these
parts over a 12,000 hour period. Clean them more often than this if you use
the projector in a environment that is dustier than expected. (Assuming the
projector is used in an atmosphere in which airborne particulate matter is less
than 0.04 to 0.2 mg/m3.)
Attention
If regular maintenance is not performed, your Epson projector will notify you
when the temperature inside the projector has reached a high level. Do not wait
until this warning appears to maintain your projector filter as prolonged exposure
to high temperatures may reduce the life of your projector.
gg Related Links
• "Cleaning the Air Filter" p.59
• "Replacing the Air Filter" p.60
Cleaning the Air Filter
You need to clean the projector's air filters in the following situations:
• The filter or vents get dusty.
a
Turn off the projector and unplug the power cord.
b
Slide the air filter cover latch and open the air filter cover.
c
Pull the air filter out of the projector.
d
Vacuum the front of the air filter (the side with the tabs) to remove any
remaining dust.
Attention
• Do not rinse the air filter in water, or use any detergent or solvent to
clean it.
• Do not use canned air. The gases may leave a flammable residue or push
dust and debris into the projector's optics or other sensitive areas.
To Next Page
Loading...
