88
4. Vacuum the front of the air filter (the side with the tabs) to remove any remaining dust.
Caution: Do not rinse the air filter in water, or use any detergent or solvent to clean it. Do not use
canned air; the gases may leave a flammable residue, or push dust and debris into the projector's
optics or other sensitive areas.
Note: If dust is difficult to remove or the air filter is damaged, replace the air filter.
5. Place the air filter back in the projector with the four tabs facing down as shown.
6. Close the air filter cover until it clicks into place.
Caution: Do not try to force the air filter cover closed if the tabs of the air filter are facing up. You
could damage the projector.
To Next Page
Loading...
