Useful Functions
49
HDMI Link
HDMI Link Function
When an AV device that meets the HDMI CEC standards is connected to the projector's HDMI port, you can
perform linked operations such as linked power on and volume adjustment for the AV system from one
remote control. Also, when projecting images in WirelessHD, you can use the HDMI link function (EH-
TW6000W only).
c
As long as the AV device meets the HDMI CEC standards, you can use the HDMI link function even
if the AV system in-between does not meet the HDMI CEC standards.
Connection Example
Projector Amplifier Player
HDMI Link Settings
Enabling HDMI Link
By pressing the button on the remote control, and
setting HDMI Link to On, you can operate the following
functions.
Function Explanation
Power On Link Powers on the projector when content is played back on the connected device. Or,
powers on the connected device when the projector is turned on.
Power Off Link Powers off the connected device when the projector is turned off.
•
This only works when the connected device's CEC power link function is enabled.
•
Note that depending on the status of the connected device (for example, if it is record-
ing), the device may not power off.
Audio Out Device When an AV system is connected, you can set whether to output audio from the pro-
jector's speaker, or from the AV system's speaker.
Input Change Link Changes the input source of the projector to HDMI when content is played back on the
connected device.
Connected Devices
Operations
You can perform operations such as Play, Stop, Fast Forward, Rewind, Next Chapter,
Previous Chapter, and Pause from the remote control for the projector.
To Next Page
Loading...
Need help?
General
