Basic Operations
33
Adjusting the Volume
You can control the volume using the [Volume] buttons on the remote control, or the Volume buttons on
the control panel (EH-TW7100 only).
Remote control Control panel
c
•
You can also adjust the volume from the Configuration menu. s Settings - Audio - Volume p.62
•
When an AV System is connected to the projector and you want to adjust the volume for the AV system,
set HDMI Link to On and Audio Out Device to AV System.
s Settings - HDMI Link p.62
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume before powering off, so
that you can power on and then gradually increase the volume.
Hiding the Image and Muting the Audio Temporarily (A/V Mute)
Press the [A/V Mute] button on the remote control to show or hide the image. The audio is also muted or
played.
c
•
For movies, the image and audio continue to play even during A/V Mute. You cannot resume from the
point that you muted the video and audio using the [A/V Mute] button.
•
To mute or play only the audio, press the [Mute] button.
•
When outputting audio from an AV system and you want to adjust the volume for the AV system, set
HDMI Link to On and Audio Out Device to AV System.
s Settings - HDMI Link p.62
To Next Page
Loading...
