Adjusting the Image
40
Viewing the Image at the Saved Image Quality
(Memory Function)
Saving a Memory
By using the memory function, you can register the following adjustment values, and then load them when
necessary.
•
Image setting from the Configuration menu
•
Lens Adjustment Function (Focus, Zoom, Lens Shift) adjustment values s p.27
a
Make the settings or adjustments you
want to register.
b
Press the button.
c
Use the buttons to
select Save Memory or Save Lens
Position, and then press the
button to confirm the selection.
Save Memory: Registers the Image
settings
Save Lens Position: Registers the
adjustment value for the lens adjustment
function
d
Use the buttons to
select the memory name to be saved,
and then press the
button to
confirm the selection.
The current projector settings are saved to
the memory.
If the mark on the left of the memory name
is turned aqua, it means the memory has
already been registered. When you select a
registered memory, a message is displayed
asking you to confirm that you want to
overwrite the memory. If you select Yes, the
previous content is erased and the current
settings are saved.
Loading, Deleting, and Renaming a Memory
You can load, delete, and rename registered memories.
Press the
button, and then select the target function on the screen displayed.
c
•
Press the buttons on the remote control to load the lens position from the Save Lens
Position registered in Memory1 or Memory2.
•
The position of the lens when loading the memory and the position of the lens when the memory is
registered may not be exactly the same.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
