EasyManuals Logo

Epson EH-TW7400 User Manual

Epson EH-TW7400
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
Troubleshooting
79
Check Remedy
Is the contrast adjusted correctly?
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.59
Is the color adjusted correctly?
Adjust the Advanced setting from the Configuration menu.
s Image - Advanced p.59
(Only when projecting images from a video
device)
Are the color saturation and tint adjusted cor-
rectly?
Adjust the Color Saturation and Tint settings from the Config-
uration menu.
s Image - Color Saturation/Tint p.59
Images appear dark
Check Remedy
Is the image brightness set correctly?
Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.59
Is the contrast adjusted correctly?
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.59
Is it time to replace the lamp? When the lamp is nearly ready for replacement, the images be-
come darker and the color quality becomes poorer. When this
happens, replace the lamp with a new lamp.
s p.87
Projection stops automatically
Check Remedy
Is Sleep Mode enabled?
If the set time is exceeded and no signal is input, the lamp is
automatically turned off and the projector enters standby mode.
The projector returns from standby status when you press the
button on the remote control or the button on the con-
trol panel. If you want to disable Sleep Mode, change the setting
to Off.
s Extended - Operation - Sleep Mode p.65
Problems when projection starts
The projector does not turn on
Check Remedy
Is the power turned on?
Press the
button on the remote control or the button
on the control panel.
Is Child Lock set to On? When Child Lock is set to On from the Configuration menu, hold
down the
button on the control panel for approximately
three seconds, or perform operations from the remote control.
s Settings - Lock Setting - Child Lock p.62
Do the indicators turn on and off when the
power cord is touched?
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
s Epson Projector Contact List

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW7400 and is the answer not in the manual?

Epson EH-TW7400 Specifications

General IconGeneral
Matrix size0.74 \
Number of colors1.07 billion colors
Native aspect ratio16:9
Projection distance3 - 6.3 m
Vertical scan range192 - 240 Hz
Projection technology3LCD
Contrast ratio (typical)200000:1
Screen size compatibility50 - 300 \
Projector native resolutionWUXGA (1920x1200)
Keystone correction, vertical-30 - 30 °
Throw ratio1.35 - 2.84:1
Zoom capabilityYes
Focal length range22.5 - 46.7 mm
Aperture range (F-F)2 - 3
Vertical lens shift range-96.3 - 96.3 %
Horizontal lens shift range-47.1 - 47.1 %
Lamp typeUHE
Lamp power250 W
Light source typeLamp
Service life of light source3500 h
Service life of light source (economic mode)5000 h
Video processing10 bit
Video color modesCinema, Dynamic, Natural, Bright cinema
Supported 3D formatsSide by side, Top and bottom
3D video colour modes3D Dynamic, 3D Cinema
Analog signal format systemNot supported
DVI portNo
Audio (L/R) in-
Composite video in0
Serial interface typeRS-232
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
PlacementCeiling, Desktop
Product typeStandard throw projector
Product colorWhite
Market positioningHome cinema
Cable lock slot typeKensington
Noise level31 dB
Country of originChina
2D/3D frequency image240/480 Hz
Noise level (economic mode)20 dB
Power sourceAC
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.2 W
Power consumption (typical)355 W
Power consumption (economy mode)271 W
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)10 - 90 %
Cables includedAC, HDMI
Pallet width800 mm
Pallet height2510 mm
Pallet length1200 mm
Pallet weight0 g
Pallet width (UK)1000 mm
Quantity per pack1 pc(s)
Quantity per pallet16 pc(s)
Quantity per pallet layer2 pc(s)
Harmonized System (HS) code85286200
Software supportvia: AMX, Crestron (Network), Control4
Weight and Dimensions IconWeight and Dimensions
Depth450 mm
Width520 mm
Height193 mm
Weight11200 g
Package depth655 mm
Package width512 mm
Package height260 mm
Package weight14425 g

Related product manuals