17
Connecting to a Computer
Some workstation-type computers have a 13w3 monitor port.
Use a commercially-available 13w3 ⇔ D-Sub 15-pin cable to connect the
Computer/Component Video port at the rear of the projector to the monitor
port of the computer.
If the Monitor Port is a 13w3 Port
13w3 cable
(commercially-available)
To monitor port
To Computer/
Component
Video port (blue)
TIP
• After projection starts, change the "Input Signal" setting in the
"Video" menu to "Computer".
p.46
• If more than one external component is connected to the projector,
use the [Source] button on the projector's control panel or the
[Computer] button on the remote control to select the Computer port
as the input source.
p.28
• Do not bind the power cable and the computer cable together,
otherwise image interference or errors in operation may result.
• Some workstations may require a special cable. Consult the
workstation manufacturer for further details.
To Next Page
Loading...
