Epson EMP-73 User Manual

Adjustments
Turning Off the Projector
Turn off the power for all sources connected to
the projector.
Press twice to turn off the power.
The Power indicator will flash orange (cool-down in
progress/about 20 seconds).
Check that the Power indicator lights orange,
and then disconnect the power cable from the
electrical outlet.
1
2
3
User's Guide
"Adjusting the Screen Image"
User's Guide
"Turning Off the Projector"
The following adjustments can also be made.
Automatic setup (only when computer images are projected)
User's Guide "Adjusting Computer Images"
When projecting computer images, the input signals are detected automatically and
adjusted so that the optimum images are projected. If the results of automatic adjustment
are not satisfactory, individual settings can also be adjusted manually using the menus.
Other adjustments User's Guide "Using the Configuration Menu Functions"
Press [Menu] on the remote control to display the configuration menu. You can use the
configuration menu functions to adjust setting such as brightness, contrast and colour.
Tip
While pressing the foot adjust buttons at either side, lift up the
front of the projector.
When the desired angle is obtained, release the foot adjust
buttons.
When the projector is tilted, it will cause keystone distortion to
appear in the image, but this distortion can be corrected using the
automatic keystone correction function as long as the vertical
angle of tilt is within a range of approximately 15˚. If you would like
to make further minor adjustments to the effects of automatic
keystone correction, use [keystone] on the projector's control
panel.
Power indicator
Adjusting the image
size and focus
Operating problems
may occur if the power
cable is disconnected
while the Power
indicator is flashing
orange.
Foot adjust button
Front adjustable feet
Adjusting the image angle
Turn the focus ring to adjust the
focus.
Turn the zoom ring to adjust the
image size.
Turn to the "W" side to increase
the image size, and turn to the "T"
size to reduce the image size.
Fine adjustments to
image size
Adjusting the focus
Downloaded from: http://www.usersmanualguide.com/

Epson EMP-73 Specifications

Projection and Display

native resolution	XGA
aspect ratio	4:3
pixel number	786432 dots (1024x768) x3
screen size (projected distance)	30 to 300 inch (0.9 to 10.5 m)
display performance	NTSC: 550 line PAL: 550 line

Optical Specifications

lamp type	165W UHE
lamp life	1500H
focal length	21.3-25.6 mm
zoom ratio	Digital Zoom (1.0-1.2)
f-number	1.70-1.87

Power

power supply voltage	100-120V / 200-240V ±10%, 50/60Hz AC
power cord length	3 m
computer cable length	1.8 m

Operating Environment

operating temperature	5°C to 35°C
high brightness mode fan noise	36 dB
low brightness mode fan noise	33 dB

Weight and Dimensions

width	315 mm
depth	240 mm
height	87 mm
maximum height	97 mm
weight	2.9 kg