106
Saving a User's Logo
User’s Guide
Select "Yes" in the sub-menu, then press the [Enter]
button.
The image to be recorded and a selection marquee
box will be displayed. Move the marquee box to select
the part of the image to use.
Tilt the [ ] button on the remote control or press the [ ], [ ],
[ ] and [ ] buttons on the projector's control panel to select the
area of the image to use as the user's logo, and then press the
[Enter] button.
When you press the [Enter] button on either the remote control or the
projector's control panel, the image signal will be displayed at their
original resolution, so if a signal with a resolution that is different
from the panel resolution of the projector is projected, or if a video
image is being projected, the display size will change.
To Next Page
Loading...
