Saving a User's Logo
58
D
Move the box to select the part of the image to use
as the user's logo.
E
When "Select this image?" is displayed, select
"Yes".
F
Select the zoom factor from the zoom setting
screen.
G
When the message "Save this image as the User's
Logo?" is displayed, select "Yes".
The image is saved. After the image has been saved, the message
"Completed" is displayed.
q
You can save at up to 400
^
300 dots in size.
Using the remote control Using the control panel
q
• Saving the user's logo may take about 15 seconds. Do not
use the projector or any connected equipment while it is
saving. This may cause malfunctions to occur.
• Once a user's logo has been saved, the logo cannot be
returned to the factory default.
To Next Page
Loading...
