60
Maintenance
C
Loosen the two lamp fixing screws.
Loosen the two lamp fixing screws with the screwdriver that is
supplied with the spare lamp (or your own cross head
screwdriver).
D
Take out the lamp.
Hold the lamp as shown in the illustration below and lift it up
and out of the projector.
If the lamp is broken replace it with a new lamp, or contact your
local dealer for further advice. If replacing the lamp yourself,
be careful to avoid pieces of broken glass.
E
Install the new lamp.
Insert the new lamp so that the lamp fits in place correctly and
once it is fully inserted, tighten the two screws.
F
Install the lamp cover.
Slide the lamp cover and tighten the cover fixing screws.
•Install the lamp securely. If the lamp cover is removed,
the lamp turns off automatically as a safety precaution.
Moreover, the lamp will not turn on if the lamp or the
lamp cover is not installed correctly.
•This product includes a lamp component that contains
mercury (Hg). Please consult your state and local
regurations regarding disposal or recycling. Do not put
in the trash.
To Next Page
Loading...
