266
6. Moisten a cotton swab with the water and detergent mixture and squeeze out any excess moisture,
then lightly wipe the ink off the translucent film.
Caution: Do not press too hard on the film or you may dislocate the anchor springs and damage
your product.
7. Use a new, dry cotton swab to dry the translucent film.
8. Repeat steps 6 and 7 as necessary to clean all ink smears.
9. When the translucent film is dry and free of any fibers, close the scanner unit.
10. Reconnect any disconnected cables, plug in the power cord, and turn on the product.
Parent topic: Cleaning and Transporting Your Product
Cleaning the Paper Rollers
If you encounter repeated paper feed issues from the cassette, clean the paper rollers inside the
product.
1. Turn off the product.
2. Unplug the power cable.
3. Disconnect any connected cables.
To Next Page
Loading...
