78
• Load one sheet of loose-leaf or other paper with holes facing as shown. You can load one sheet at
a time in only these sizes: Letter (8.5 × 11 inches [216 × 279 mm]), A4 (8.3 × 11.7 inches
[210 × 297 mm]), 8.5 × 13 inches (216 × 330 mm), or Legal (8.5 × 14 inches [216 × 356 mm]).
Note: Two-sided printing is not available on hole-punched paper.
4. Slide the edge guides against the paper, but not too tightly.
5. Select Settings > General Settings > Printer Settings > Paper Source Settings > Paper Setting
to select the size and type of paper you loaded. If your paper size is not displayed, select User
Defined.
Note: If you are printing on letterhead, select Letterhead as the paper type. If you select Letterhead
and you are printing on paper that is smaller than the printer driver setting, make sure you select the
correct paper size setting or the printer may print beyond the edges of the paper. Two-sided printing
is not available on letterhead paper.
To Next Page
Loading...
