EasyManua.ls Logo

Epson ET-4800 - Network Interface Specifications

Epson ET-4800
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
305
Network Interface Specifications
Wi-Fi
Standard IEEE 802.11 b/g/n; IEEE 802.11n available only on the 20 MHz
channel
Security WPA2-PSK (AES); complies with WPA2 with support for
WPA/WPA2 Personal
WEP (64/128 bit); not supported for Wi-Fi Direct mode
WPA3-SAE (AES); not supported for Wi-Fi Direct mode
Frequency range 2.4 GHz
Maximum Radio-Frequency
Power Transmitted
20 dBm (EIRP)
Connection modes Infrastructure mode
Wi-Fi Direct (Simple AP); not supported for IEEE 802.11b
Note: Infrastructure and Wi-Fi Direct modes can be used
simultaneously.
Ethernet
Standard IEEE802.3i (10BASE-T); use a category 5e or higher STP (Shielded
Twisted Pair) cable to prevent risk of radio interference
IEEE802.3u (100BASE-TX)
IEEE802.3az (Energy Efficient Ethernet); disabled by default (see
link below to enable)
Note: The connected device should be IEEE802.3az compliant
Communication mode Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps Full
duplex, 100Mbps Half duplex
Connector RJ-45
Security Protocol
SSL/TLS: HTTPS Server/Client, IPPS

Table of Contents

Related product manuals