Setting Up the Projector 17
Try to place the projector directly in front of the center of the screen,
facing it toward the screen squarely. If the projector isn’t positioned
this way, the image will be “keystone” shaped, instead of square or
rectangular.
If you place the projector below the level of the screen, you’ll have to
tilt it up by extending the front adjustable foot, as described on
page 38. This also causes the image to lose its rectangular shape. You
can adjust the shape using the buttons on the projector (see page 38),
or using the projector’s menu system (see page 61).
The Auto Keystone feature corrects the distortion automatically. See
page 62 for more information about Auto Keystone correction. If
necessary, you can adjust the image shape manually as described on
page 38.
Other Installations
You can also project from behind the screen or from the ceiling, with
the projector mounted upside-down:
To project from overhead, you’ll need the optional ceiling mount
hardware. (See page 14 for ordering information.) You’ll also need to
select
Front/Ceiling or Rear/Ceiling for the Projection option in the
Extended menu. To project from the rear, select
Rear. See page 63 for
more information.
note
The Auto Keystone feature
corrects vertical distortion
automatically. For more
information, see page 38.
Front/ceiling projectionRear projection (using a
translucent screen)
Rear/ceiling projection (using
a translucent screen)
To Next Page
Loading...
Need help?
General
