Epson Home Cinema 5050UB User Manual

57
Turning Off the Projector
Before turning off the projector, shut down any computer connected to it so you can see the computer
display during shutdown.
Note: Turn off this product when not in use to prolong the life of the projector. Lamp life will vary
depending upon mode selected, environmental conditions, and usage. Brightness decreases over time.
Note: When using the Blank feature, the projector lamp is still on. To turn off the lamp, turn off the
projector.
1. Press the power button on the projector or the Standby button on the remote control.
The projector displays a shutdown confirmation screen.
2. Press the power button on the projector or the Standby button on the remote control again. (To
leave it on, press any other button.)
The lamp turns off and the lens shutter closes. The projector's Status light flashes and then turns off.
Note: If you unplug the projector before the Status light stops flashing and need to turn the projector
back on, wait until the lamp has cooled down (about 10 minutes), plug the power cord back in, and
turn the projector on again. You cannot operate the projector until it finishes cooling down.

Epson Home Cinema 5050UB Specifications

General

Matrix size	0.74 \
Matrix type	3-panel (p-Si TFT active)
Number of colors	1.073 billion colors
Native aspect ratio	16:9
Projection distance	1.48 - 18.99 m
Projection technology	3LCD
Supported aspect ratios	4:3, 16:10, 16:9
Contrast ratio (typical)	1000000:1
Screen size compatibility	50 - 300 \
Projector native resolution	DCI 4K (4096x2160)
Lamp type	UHE
Lamp power	250 W
Light source type	Lamp
Service life of light source	4000 h
Service life of light source (economic mode)	5000 h
Focus	Auto
Focal length range	22.5 - 46.7 mm
Aperture range (F-F)	2 - 3
Full HD	Yes
Video color modes	Cinema, Dynamic, Natural
Supported video modes	480i, 480p, 576i, 576p, 720p, 1080i, 1080p
Analog signal format system	-
DVI port	No
Serial interface type	RS-232C
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	0
Noise level	31 dB
Placement	Ceiling
Product type	Ceiling-mounted projector
Product color	White
Market positioning	Home cinema
Cable lock slot type	Kensington
Power source	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	373 W
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	- g