Description
Epson IMU_OEM7 Interposer Board Seiko Epson Corporation 1
User Manual (Rev. 1.3)
1. Description
This document describes the Epson IMU_OEM7 Interposer Board (referred to as EIIB). The purpose of
the EIIB is solely for prototype and evaluation in a laboratory or development environment when using
the Epson G2 and V series IMU with the NovAtel OEM7 Development Kit.
The EIIB is a simple board that mounts directly onto the designated “IMU Board” area of the OEM7
Development Kit and routes all the necessary interface signals to the designated connector.
This product is intended for use by qualified engineers familiar with electronics or software development
and should not be used as all or part of a finished end product.
To Next Page
Loading...
