Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
C
M-192G
Designer’s Guide
(STANDARD)
8 7
1. Apply a buffer material such as rubber to the printer mounting screws to prevent the printer
vibration from traveling directly to the case.
2. Improve the strength of the case by thickening the case as much as possible or by applying
ribs or other parts to reduce the degree of the resonance of the case.
5) Attach the ground wire using the printer frame mounting holes (figure 2.2.1; #3 or #4).
END
To Previous Page
