2
a Remove the protective tape and film covering
the machine, and also from the LCD.
b Make sure you have all the components.
2
Load plain A4 paper
a Pull the paper tray a completely out of the
machine.
b Open the output paper tray cover a.
c With both hands, gently press and slide the
paper length guide a and then the paper side
guides b to fit the paper size.
Make sure that the triangular marks c on the
paper length guide a and paper side guides b
line up with the mark for the paper size you are
using.
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Gently put the paper into the paper tray print
side down and top edge first. Check that the
paper is flat in the tray.
• Save all packing materials and the box in case
for any reason you must ship your machine.
• For a network connection you will need to
purchase a network interface cable.
Please use the supplied USB cable for a USB
connection.
USB cable
It is recommended to use a USB 2.0 cable
(Type A/B) that is no more than 2 metres long
(use cable that is supplied).
Network cable
Use a straight-through Category5 (or greater)
twisted-pair cable for 10BASE-T or
100BASE-TX Fast Ethernet Network.
Always make sure that the paper is not curled or
wrinkled.
Be careful that you do not push the paper in
too far; it may lift at the back of the tray and
cause paper feed problems.
B5JIS
EXE
Photo 2LL
4×6in
10×15cm
A4 B4JIS
LT R
LGL
LGR
1
3
2
3
To Next Page
Loading...
Need help?
General
