Epson Perfection 4490 Photo - Page 52

EPSON Perfection 4490 Photo Revision B
Disassembly / Assembly Disassembly Procedure 52
8. Remove the Protective Cover from the TPU Inverter Board.
Figure 4-40. Removing the TPU Inverter Board (2)
Protective Cover
 When installing the TPU Inverter Board to the TPU Carriage
Frame, match the positioning holes and the guide pins as shown
in the figure below.
 When connecting CN2 and CN3 Connector Cables, route them
under the tab (DRV Inverter FFC Tab) as shown in the figure
below.
Figure 4-41. Routing the DRV Inverter Cables
 When connecting the DRV Inverter FFC to the TPU Inverter
Board, put the FFC through the tab (DRV Inverter FFC Tab)
as shown in Figure 4-38
.
 Secure the DRV Inverter FFC with a piece of acetate tape at the
position shown in Figure 4-38
.
CN3
CN2
Positioning Holes and Guide Pins
Tab (DRV Inverter FFC Tab)