61
You see a confirmation screen:
5 Press OK again to clean the print head. Cleaning
takes about 60 seconds. PictureMate makes some
noise and you see an Auto Cleaning message.
When cleaning is complete, PictureMate prints a
nozzle check pattern and displays this screen:
6 Check the pattern to see if there are any gaps or
missing lines.
● If the pattern is OK, press OK to finish.
● If the pattern has gaps or missing lines, press
Back to clean the print head again. You
may need to clean it two or three times
before the nozzles are clean.
If you don’t see any improvement after cleaning three
times, see “Print Quality Problems” on page 65.
Note: You can run a nozzle check before you clean the print
head. Follow steps 1 through 3 on page 60. Then select
Nozzle
Check
.
OK
Needs
cleaning
To Next Page
Loading...
