Epson PLQ-50M

Messages Problems and Solutions
State of Lights Beep pattern
Remove paper.
❏ Paper is not fully ejected. Press the F1/Eject button to eject paper or
see “Clearing a Paper Jam” on page 58 for instructions on ejecting
paper.
❏ Paper is jammed in the printer. Clear the paper jam, see “Clearing a
Paper Jam” on page 58 or press the Offline button to clear the error.
❏ The paper size setting may not match the size of the paper you are
using. Check if they match.
N Power
F Ready
N Offline
Printer error There can be a variety of causes. It can also be due to your application
software. Contact your administrator for help.
N Power
F Ready
Close the printer cover. The printer cover is open. Stop the operation and close the printer cover.
N Power
N Offline
or —
Printing stops due to overheating of the print
head. Wait till the head cools.
The print head is overheated. Wait for a few minutes; the printer resumes
printing automatically once the print head cools.
N Power
F Offline
—
Printer error. Contact Epson Support.
Non-printing features are available.
An unknown printer error has occurred. Turn off the printer and leave it off
for several minutes; then turn on the printer again. If the error recurs,
contact your dealer.
N Power
F Ready
F F1/Eject
F Offline
F F2
N = on, F = flashing
= short series of beeps (three beeps)
= long series of beeps (five beeps)
= short series of beeps (five beeps ×2)
PLQ-50/PLQ-50CS/PLQ-50M/PLQ-50CSM/PLQ-50CSK User’s Guide
Troubleshooting 52