Troubleshooting
41
Cannot connect in Advanced Connection Mode.
Is the firewall turned off, or has the firewall been
registered as an exception?
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Is Wireless LAN Power set to Off in the Wireless LAN menu
from the projector's Configuration menu?
Set Wireless LAN Power to On in the Wireless LAN menu from the Configuration menu.
See your projector User’s Guide for details on the projector's wireless LAN settings.
Is the AirMac setting for Mac OS correct? Check that AirMac is set to on. Or, check whether an appropriate access point has been selected.
Check Remedy
Is the SSID setting different? Set the computer, the access point, and the projector to the same SSID.
You can make the SSID setting from the projector's Network menu.
See your projector User’s Guide for details.
Is the same WEP key set? When selecting WEP from Security, set the access point, the computer, and the projector to the same
WEP key.
See your projector User’s Guide for details on the WEP key.
Are the connection denial functions, such as MAC
Addressg restrictions and port restrictions, set correctly at
the access point?
Set connection permission at the access point to allow projectors to connect.
Are the IP address, the subnet mask, and the gateway
address for the access point and the projector set
correctly?
When not using a DHCP, adjust each setting.
You can make the DHCP setting from the projector's Network menu.
See your projector User’s Guide for details.
Are the access point and the projector's subnet different? Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced
Connection Mode Only)" p.17
Have you enabled DHCP? When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby
status if an available DHCP server is not found.
Check Remedy
To Next Page
Loading...
Need help?
General