Troubleshooting
42
When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection
cannot be made from another computer.
Cannot select or change the connection mode.
The screen is not projected.
The Slide Show cannot be displayed on the desired display when the multi-screen display function is being executed.
Check Remedy
Did the presenter leave the conference room without
cutting off the network connection?
With EasyMP Network Projection, the computer currently connected can be disconnected when
another computer tries to connect to the projector.
Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector
Keyword, you can disconnect the computer currently connected and then connect your computer to
the projector.
When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart
the projector and reconnect.
Check Remedy
Is EasyMP Network Projection set to start up using the
same connection mode?
Select Display Connection Mode Selection window on startup on the General settings tab from
Set options. The projector selection screen is displayed after restarting EasyMP Network Projection.
Check Remedy
Are you using PowerPoint 2002 or an earlier version?
(For Windows)
To set and use two or more virtual displays
g, use PowerPoint 2003 or later, or limit the number of
virtual displays to one before displaying the Slide Show.
To Next Page
Loading...
Need help?
General