30
7. Adjust the arm length
1. Loosen the screw on the arm ( ).
2. Adjust the length of the arm using the measure on the bottom to match the projection distance
recommended in “Positioning the Projector” on page 14 ( ).
3. After adjusting the length, secure the arm position temporarily by tightening the screw on
top ( ).
8. Attach the interface cover bracket
Attach the interface cover bracket using the hexagonal wrench (M4) and two M4 × 12 mm bolts with
washers.
M4 × 12 mm hexagon
socket head cap bolt
with washer (×2)
Interface cover bracket
Installation.book Page 30 Tues day, October 30, 2012 5:53 PM
To Next Page
Loading...
