What to do if my Epson software cannot connect to the projector via wired LAN?
First, ensure that LAN is available from the device manager under Control Panel - System - Hardware. Then, check that the network cable is correctly connected; reconnect it if necessary.
How to fix Epson software when it cannot connect to the projector?
Install the current version of EasyMP Network Projection from the EPSON Projector Software CD-ROM supplied with the projector. You can download the latest version of EasyMP Network Projection from www.epson.com and select your location.
Why can't I connect to the Epson PowerLite 470 Projector via the network?
Several factors could be preventing the connection. Ensure you close network settings on the projector and return to the LAN standby screen, as connection via EasyMP Network Projection isn't possible if the network configuration screen is active. If your computer uses multiple LAN environments, verify the correct network adapter is selected within EasyMP Network Projection under 'Set options - Switch LAN'. If you prefer not to disable your firewall, ensure ports 3620, 3621, and 3629 are open. Also, verify that the computer, access point, and projector share the same SSID. Finally, confirm that the access point permits projector connections and that DHCP settings are correctly configured if you're not using DHCP.
What to do if EasyMP Network Projection initialization failed on Epson?
Restart EasyMP Network Projection. If the message persists, uninstall and then reinstall EasyMP Network Projection.
How to resolve Epson EasyMP Network Projection connection failure due to keyword mismatch?
Check the Projector Keyword displayed on the LAN standby screen and ensure it matches the one you are using to connect.
What to do if my Epson software cannot start while Quick Wireless Connection is running?
Close Quick Wireless Connection and then start EasyMP Network Projection.
Why is there no audio from the Epson PowerLite 470 Projector when connecting with EasyMP Network Projection?
Audio can only be transferred to one projector, so try disconnecting other projectors. Also, ensure you select 'Output audio from the projector' on the Audio Output tab.
What to do if Epson EasyMP Network Projection cannot select or change the connection mode?
Select 'Display Connection Mode Selection window on startup' on the General settings tab from Set options. The projector selection screen is displayed after restarting EasyMP Network Projection.
What to do if the Epson mouse cursor is not displayed on the computer screen?
When the virtual display checkbox is cleared on the Add-Remove Virtual Display screen, the mouse pointer returns to the screen display area.
What to do if the Epson mouse pointer flickers?
If you do not want the mouse pointer to flicker, clear the Transfer layered window check box on the Adjust performance tab.
To Next Page
General