Input Signal Settings - Signal Menu
Normally the projector detects and optimizes the input signal settings automatically. If you need to
customize the settings, you can use the Signal menu. The available settings depend on the currently
selected input source.
Note: You can restore the default settings of the Position, Tracking, and Sync. settings by pressing the
Auto button on the remote control.
To change settings for an input source, make sure the source is connected and select that source.
Setting Options Description
Auto Setup On Automatically optimizes
computer image quality (when
Off
On)
Resolution Auto Sets the input signal resolution if
not detected automatically using
Normal
the Auto option
Wide
Tracking Varying levels available Adjusts signal to eliminate
vertical stripes in computer
images
133
To Next Page
Loading...
