94 Monitoring the Projector Over a Network
Selecting Network Settings
Follow the instructions in this section to set up the projector’s
network settings in the menu system.
1. Press the
Menu button.
2. Select the
Network menu.
3. Press
Enter. Then use the up and down arrow buttons and the
Enter button to set the following options:
■ Wired LAN
If your network assigns addresses automatically, turn on the
DHCP setting.
If your network does not assign addresses automatically, turn
off
DHCP and enter the projector’s IP Address, Subnet
Mask
, and Gateway Address as needed.
To enter numbers, use the numeric buttons on the remote
control.
■ PJLink Password
Lets you enter a password for using the PJLink
™
protocol to
control the projector.
■ Web Control Password
Lets you enter a password for accessing the projector over the
web from a computer running the EMP Monitor software.
To Next Page
Loading...
Need help?
General