Epson PowerLite EMP-1810 User Manual

178 Maintaining the Projector
3. Select
Reset Lamp Hours and press Enter.
4. When you see the prompt, select
Yes and press Enter.
5. When you’re finished, press
Menu to exit the menu system.
Checking Lamp Usage
To check the number of hours the lamp has been used, press the
Menu button and highlight the Info menu. You see a screen like this:
The life span of the lamp is about 2500 hours if the
Brightness
Control
setting in the Settings menu is set to High (default), and
3000 hours if the
Brightness Control setting is set to Low. Make
sure you have a spare lamp handy if the usage hours on this menu
are close to the life span of your lamp.
note
The information displayed
depends on the input signal
currently selected.

Epson PowerLite EMP-1810 Specifications

General

Resolution	XGA (1024 x 768)
Zoom	1.2x
Display Technology	3LCD
Aspect Ratio	4:3
Lamp Type	UHE
Projection Size	30 - 300 inches
Lamp Life	4000 hours
Input Ports	VGA, Composite Video, S-Video
Output Ports	VGA
Noise Level	35 dB