❏ You cannot use the bindery print server mode with EpsonNet Config if you are running Novell
Client for Windows 95/98 version 3.00 or Novell Client for Windows NT version 4.50. To
configure the network interface for bindery mode, use Novell IntranetWare Client or EpsonNet
Config with Web Browser.
See your NetWare documentation for more information.
Time required to recognize the network interface
It takes up to two minutes for the NetWare server to recognize the network interface, after the printer
is turned on. During this start-up time, the status sheet does not show the correct information.
Frame type
The same frame type should be used for the NetWare server and IPX router on the same network. If
more than one frame type is used on the same network, bind all the frame types to the NetWare
servers and IPX routers.
For NetWare 5.x
The IPX protocol must be installed (bound) on the NetWare 5.x server.
About modes
If the mode you have logged in is different from the mode you set for the network interface, a message
appears when you try to configure the network interface for NetWare. If you do not want to change
the current settings, click Cancel and log in again using the same mode set for the network interface.
Using Bindery Print Server (NetWare 3.x/4.x)
This section contains instructions on using the network interface in the Print Server mode on
NetWare 3.x/4.x/IntranetWare with Bindery emulation.
Note:
The network interface in the Print Server mode of NetWare 3.x does not allow you to use the Print
Server status display control with PCONSOLE.
1. Turn on your printer.
2. From any NetWare client, log in to the target NetWare server with supervisor privileges. You
must log in with the bindery connection.
EPSON Network Guide
How To 78
To Next Page
Loading...
Need help?
General