Epson Pro L12000QNL - Input Sources for Split Screen Projection; Using Advanced Image Adjustment Features

156
5. To select an input source for the other image, select the Source setting, press Enter, select the
input source, select Execute, and press Enter. (You can also change image sources, if necessary.)
6. To switch the images, select the Swap Screens setting and press Enter.
7. To change the image sizes, select the Screen Size setting, press Enter, select a sizing option,
press Enter, and press Menu to exit.
Note: Depending on the video input signals, the images may not appear at the same size even if you
choose the Equal setting.
8. To exit the split screen feature, select Exit Split Screen or press the Esc button.
Input Sources for Split Screen Projection
Parent topic: Adjusting Projector Features
Input Sources for Split Screen Projection
You can choose most input source combinations for split screen projection, except the following:
• Computer and LAN
• SDI and SDI
• HDMI and DVI-D
Note: If you installed the optional DisplayPort interface board, you also cannot choose the port 1 and
port 2 input sources for split screen projection. The split screen feature supports signals up to 4k30p for
DisplayPort sources.
Parent topic: Projecting Two Images Simultaneously
Using Advanced Image Adjustment Features
Follow the instructions in these sections to use your projector's advanced image adjustments.
Creating Image Presets
Adjusting Detail Enhancement
Adjusting the Color Convergence (Panel Alignment)
Adjusting the Color Tone (Color Uniformity)
Running Light Source Calibration
Parent topic: Adjusting Projector Features