216
Setting Options Description
SDI Settings Link Type
Manual Settings
Select the signal settings for the
SDI port installed in slot 1 or 2
Link Type: select Single (Auto)
or Single (Manual) to configure
one screen with one input signal;
select Quad (Auto) or Quad
(Manual) to configure one screen
with four input signals or to
enable the SDI1 through SDI4
ports in the Video Terminal
Settings
Manual Settings: set various
SDI settings manually or reset
them to their default values
DisplayPort Settings Link Type Select the signal settings for an
optional DisplayPort interface
board installed in slot 1 or 2
Link Type: select Single when
connecting one input source to
either the DisplayPort 1 or 2
ports; when connecting two input
sources to the ports, select Dual
(3840x2160) so the computer
recognizes the signal as one
display (if an image is not
displayed, select Dual
(1920x2160) so the computer
recognizes the signal as two
displays)
To Next Page
Loading...
