Epson SC-P9500 Series User Manual

Problem Solver
What to do When a Message is Displayed
If the printer displays one of the messages shown below, refer to the solution listed and take the necessary steps.
Messages What to do
Change paper settings
Paper setting in the printer driver is
different from paper information
registered in the printer.
Change paper setting from the
application or the driver.
For details, see your
documentation.
To change paper information that was registered using Epson Media Installer, load the
paper and then use the control panel.
You can also use Epson Media Installer to change paper information for paper that has not
been loaded.
However, you may not be able to change the paper information depending on the version
of Epson Media Installer you are using.
TCP/IP configuration failed
The combination of the IP address
and the subnet mask is invalid.
See your documentation for more
details.
Enter the correct values for the IP address and the default gateway. Check with your
network administrator if you do not know the correct values.
SpectroProofer error NN
The SpectroProofer is not working
correctly.
See the manual for more details.
(where NN is the error number)
The solution depends on the error number. See the following table.
U “SpectroProofer Error” on page 130
SC-P9500 Series/SC-P7500 Series User's Guide
Problem Solver
129

Epson SC-P9500 Series Specifications

General

Brand	Epson
Model	SC-P9500 Series
Category	Printer
Language	English